The short answer is that, using 3D printing technology, the TickMade MagClam is more compact than a traditional Kydex design. This makes the MagClam more comfortable, and easier to conceal.

The TickMade MagClam also holds the magazine in a different position. The dummy cord retention system sits high on the magazine body, which allows the magazine to sit lower. A lower riding magazine conceals easier, and doesn’t poke you in the gut when you sit down. Short body MagClams are also available for users who want the magazine to ride higher above the belt.

Additionally, 3D printing allows for some features not normally seen on other magazine carriers. Most of the MagClam designs include a tie-down on the bottom, for securing the carrier places others can’t go. The tie-down can be used with the supplied shock cord loop, but paracord is recommended for more secure mounting.

The MagClam is printed in high grade PLA Pro from Polymaker (unless otherwise noted). PLA has great impact resistance and tensile strength. It does, however, soften at lower temperatures than Kydex. Temperatures over 200°F may cause your carrier to deform.

Of course, if your body ever reaches 200°F, then you have been cooked to “very well done”. MagClams have been left in hot cars without issues. However, placing it in a glove compartment or center console, out of direct sunlight, is highly recommended. If you do ever manage to destroy a MagClam, it comes with a lifetime replacement guarantee!